A few days ago, I started to build the Cromwell LK II. This is a nice kit in resin, well casted, however, there are some bubble in place of some rivet. My references are the excellent Landship site and this site, link provided in the Landship site : http://medlem.spray.se/landsverk/mm_strv21.htm
Regarding this last site, I plan to represent one Sweden tank (namedStridsvagn m/21), this one :
Anybody has some more pictures, information regarding the marking of the other faces ? On this site, there are no possibilities to contact the owner. I plan to use the Humbrol dark grey 67 for the base colour, then white plus pastel at the end. Next post, I will present the modification and the building process.
All the best
-- Edited by Eric at 11:59, 2007-03-31
__________________
Eric
On going : Obice da 305/17 su affusto de Stefano, Mark 1 female ...
Finished : Dennis 3 tons lorry, Jeffery Poplavko, Renault EG, Renault FT
If you check on that swedish page, on a photo of that whitewashed Strv m/21, you will see a small marking to the front: it is a white or yellow rectangle with three stylized crowns. It is the nationality marking used in the Swedish army at this time - a bit similar one used on Swedish aircraft at the same time.
And you are in luck! Black Lion decals produce a sheet with markings for the Strv m/21. Check out there site! (See the News page.)
(Just sticking my head above the water: writing this in a Hotel Room in Berlin. All work and no play makes Jack a dull boy... )
Thank you for the information. I already have the Black Lion decals, it is why I started the kit . I also saw this picture on the same page where I found the profile, and I am looking for other views to eventually place other decals, it looks like there was no marking on the side, but on the rear ? The Stridsvagn m/21 had often its number at the bottom of the rear door.
Next post for the actual status of the kit ....
__________________
Eric
On going : Obice da 305/17 su affusto de Stefano, Mark 1 female ...
Finished : Dennis 3 tons lorry, Jeffery Poplavko, Renault EG, Renault FT
I have a problem, on the internal face of the track assemblies, there are no details. Anybody has a suggestion to do them ? My idea is to make a jig smaller than the track assembly and scribe around to represent something similar of the "good" side. https://i24.photobucket.com/albums/c29/Nieuport/LK%20II/LK2_06.jpg
Thank you in advance
-- Edited by Eric at 06:59, 2007-04-01
-- Edited by Eric at 08:52, 2007-04-01
__________________
Eric
On going : Obice da 305/17 su affusto de Stefano, Mark 1 female ...
Finished : Dennis 3 tons lorry, Jeffery Poplavko, Renault EG, Renault FT
Nice! I've thought about doing a Swedish M/21 for years out of the Cromwell kit, but now that you've done it (and you've done a terrific job so far) I might not. :)
Thank you for the comment !!! Start to build this kit, it is very nice. The main point is to add some rivets. There is a lot of other marking than the one I chose.
All the very best
__________________
Eric
On going : Obice da 305/17 su affusto de Stefano, Mark 1 female ...
Finished : Dennis 3 tons lorry, Jeffery Poplavko, Renault EG, Renault FT
Found three ,one of a m/21 used as target at P3 tank regiment Strängnäs during ww2,The other is a monument tank at the same regiment ,now named P10.It was placed outside the administration building until the 90s, cheers Peter
Eric! I look forward to see more of Your LK II. I Enjoyed so much Your Gun Carrier,I am sure this new one will be another beautifull model. Best regards, EDUARDO